Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need assistance machining 1/8” thick steel flat bar
#1
I need some guidance or advice to cut 1/8” steel flat bar, I mainly just need to cut it into small strips, round a side, then countersink it 5mm from the edge.  I am replacing some components on a Lulzbot 3D printer.   Pic of diagram and physical part included in post.  If I can commission you to do this for me-Awesome!!  I think this also could be something I do myself with instruction.  

Steel flatbar from homedepot.  36in x 0.75in or 1in X .125in. $6


Attached Files Thumbnail(s)
       
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)