Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need soldering help for Raspberry Pi project
#11
OK, they are all done.

IIC Addresses are 0x60 (default) and 0x61

One thing I would recommend is to put an insulator between the two stacks where the motor connector are.
This design could cause a short circuit between a motor connector on the top and bottom hats when stacked.
Reply


Messages In This Thread
RE: Need soldering help for Raspberry Pi project - by AlanKilian - 10-17-2020, 07:19 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)