Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Welding
#1
Two 3 inch beads to weld one axle stub to one end of channel axle.  Axle stub is new and machined to fit into channel. Stub and channel are clean, ground, and ready to weld.  Welding should not take more than 15 minutes. Would like it done ASAP if possible but I can wait if need be.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)